Iron-On Application

Carefully Remove Transfer from It's Packaging!

1. Always iron on a hard, flat surface (not a padded ironing board).

2. Remove backing and check design to make sure that the elements have not shifted during shipment. Use tweezers to reposition elements if needed.

3. Place the sticky-side of the transfer paper down onto fabric. If it is not in the desired position, lift and reposition.

4. Place a cotton pressing cloth over top of the design.

5. Set the iron on the medium or wool setting. NO STEAM! You may adjust the temperature as needed

6. Iron directly on top of the pressing cloth for a minimum of 45-60 seconds. Heavier fabrics such as denim might need more time and light fabrics like silk will need less time. DO NOT MOVE THE IRON! Just let it sit in place. Press with the iron facing side-to-side then up and down to completely cover the surface.

7. Allow to cool until warm and then slowly remove the transfer paper. If your elements are not sticking to your garment, place transfer paper back down and re-apply heat. If the elements are not sticking, you are not melting the adhesive.

8. After the transfer paper is removed, turn the garment inside-out, place a pressing cloth inside the garment, place a pressing cloth over design and re-press garment for about 15 seconds with 5 seconds of pressure. This will draw the glue into the fabric of the garment.

Washing Instructions:

WASH INSIDE OUT, COLD WATER, GENTLE CYCLE. LOW HEAT OR LINE DRY OR HAND WASH LAY FLAT TO DRY. THEY CAN ALSO BE SAFELY DRY-CLEANED.

Please Note: diamontee.com takes NO responsibility for damage to garments or transfers during this process.